Your Cart is Empty
$44.00
$44.00
Sold Out
NOTE - This is a full spool of Ultra TNT Seam Seal Tape (47 yds). Are you looking for smaller amounts? Click HERE for sales by the yard.
UltraTNT™ PSA Tape is a waterproof seam repair tape with Ultra™ fiber. Constructed with two laters of 0.25 mil polyester film with light grey Ultra™ yarn inserted in the warp and bias. The backing is a pressure sensitive, high-tack, non-yellowing adhesive.
Designed to be applied to the film side of fabrics to reinforce and waterproof seams. The tape is very stretch-resistant along the length of the roll, where there are straight parallel Ultra™ yarns inserted to control stretch. The Ultra CrossPly™ yarn helps control bias stretch and adds to the tear-resistance of the tape.
Compared to stitching alone, using a quality seam sealing tape makes your finished product stronger (i.e. it lasts longer) and also more waterproof.
For some laminated fabrics, it's a must-have to prevent issues like stitch elongation.
Construction:
- 2 layers of .25 mil Polyester film
- Light grey Ultra™ yarn inserted in the warp and bias
- Pressure Sensitive adhesive backing
Note - This seam seal tape will work with all of our tapeable fabrics ( X series X-pac, ECOPAK EPLX, Challenge Ultra, Dyneema Composite Fabric, Venom, etc).
| Product Details | |
| Color | Clear/transparent |
| Film Thickness | 0.25 mil |
| Width | 1.25" |
| Weight | ~1.9 grams/foot |
| Finish/Coating | N/A |
(1) Actual material properties will vary. Values listed represent average values or estimates.
(2) Disclaimer - All information, data, recommendations, etc provided for Ripstop by the Roll products (the Information) is produced for reference only. Ripstop by the Roll assumes no liability arising from (i) the application, processing, or use made of the Information or products; (ii) infringement of the intellectual or industrial property rights of third parties by reason of the application, processing, or use of the Information or products by the Buyer. Buyer shall (i) assume such liability; and (ii) verify the information and the products.
1. Work in a room temperature of at least 70ºF.
2. Fabric should be clean and dry; if not, clean fabric surface with rubbing alcohol.
3. Peel back release paper and apply tape evenly over seam, a few inches at a time.
4. Go back over the tape, applying even pressure with rubber seam roller (or by hand).
5. Let the tape cure for 24 hours before use
